Difference between revisions of "CNC"
From Chalmers Robotförening
TimGremalm (talk | contribs) |
TimGremalm (talk | contribs) |
||
| Line 17: | Line 17: | ||
| Max-depth | | Max-depth | ||
| x00mm | | x00mm | ||
|- | |||
| Max-RPM | |||
| 3000 | |||
|} | |} | ||
=CNC Milling calculating-rules= | =CNC Milling calculating-rules= | ||
==RPM [Revolutions per Minute]== | ==RPM [Revolutions per Minute]== | ||
*RPM = M / Tooldiameter | |||
{| class="wikitable" | |||
|- | |||
! Material | |||
! RPM | |||
|- | |||
| Polrycarbonate | |||
| 20000 | |||
|- | |||
| Aluminium | |||
| 10000 | |||
|- | |||
| Nylon | |||
| 7000 | |||
|- | |||
| Steel | |||
| 5000 | |||
|} | |||
*A typical RPM could be 3000 | |||
==Feed-rate [mm/minute]== | ==Feed-rate [mm/minute]== | ||
*Feedrate = K * ToolNumberOfTeeth * RPM | |||
*K is a teeh-strok in the material | |||
*K is usally 0.05 | |||
*K is maximum of 0.2 | |||
*K defines how fine the cut should be | |||
*A typical Feed-rate could be 300 | |||
==Plunch-rate [mm/minute]== | |||
{| class="wikitable" | {| class="wikitable" | ||
|- | |- | ||
| Line 29: | Line 58: | ||
| Plunch-rate = 20% av Feed-rate | | Plunch-rate = 20% av Feed-rate | ||
|} | |} | ||
*No more than 100 | *No more than 100 | ||
Revision as of 01:04, 10 September 2013
Security
- You must have taken the CNC-course by Chalmers Robotics to run the CNC-mill
- Always follow the Checklist
Specification
| Brand | Optimum |
| Modell | |
| Max-width | x00mm |
| Max-depth | x00mm |
| Max-RPM | 3000 |
CNC Milling calculating-rules
RPM [Revolutions per Minute]
- RPM = M / Tooldiameter
| Material | RPM |
|---|---|
| Polrycarbonate | 20000 |
| Aluminium | 10000 |
| Nylon | 7000 |
| Steel | 5000 |
- A typical RPM could be 3000
Feed-rate [mm/minute]
- Feedrate = K * ToolNumberOfTeeth * RPM
- K is a teeh-strok in the material
- K is usally 0.05
- K is maximum of 0.2
- K defines how fine the cut should be
- A typical Feed-rate could be 300
Plunch-rate [mm/minute]
| Små fräs (3mm) | Plunch-rate = 20% av Feed-rate |
- No more than 100
