Velleman Vertex (Old) - Revision history

AdamSG: AdamSG moved page 3D-printer Velleman Vertex to Velleman Vertex (Old)

2017-07-31T19:10:48Z

AdamSG moved page 3D-printer Velleman Vertex to Velleman Vertex (Old)

← Older revision	Revision as of 21:10, 31 July 2017
(No difference)

Vilse at 22:55, 31 March 2015

2015-03-31T22:55:07Z

← Older revision		Revision as of 00:55, 1 April 2015
Line 23:		Line 23:
	to:		to:
	; Default end code		; Default end code
	;G1 X0 Y0 Z280 ; Get extruder out of way. Uncomment to use!		G1 X0 Y0 Z280 ; Get extruder out of way. Uncomment to use!
	M107 ; Turn off fan		M107 ; Turn off fan

	Then the bed moves down after print, so its easier to access without manually move the z-axis.		Then the bed moves down after print, so its easier to access without manually move the z-axis.

	~~Aah yes and as it says in the code: uncomment~~ to ~~use~~.~~. So remove ;~~		also change print temperature for PLA to 200 degrees Celcius instead of 210.

Vilse: Created page with "Stig Nielsen have borrowed his Velleman Vertex to robotics club. To use it, it is recommended to install some drivers & Repetierhost on your own computer and connect with the ..."

2015-03-31T22:34:00Z

Created page with "Stig Nielsen have borrowed his Velleman Vertex to robotics club. To use it, it is recommended to install some drivers & Repetierhost on your own computer and connect with the ..."

New page

Stig Nielsen have borrowed his Velleman Vertex to robotics club. To use it, it is recommended to install some drivers & Repetierhost on your own computer and connect with the 3d printer with USB cable.

go to: http://manuals.velleman.eu/article/7-connecting-the-printer-21.html
and follow instructions

when you have the repetier host down and installed, open it,
go to slicer
go to Configuration
go to Gcode
and click 'create default'
..for both Start 'G-code' and 'End G-code'

then the bed will go down a bit before it starts heating.

Also in addition you can change the 'End G-code'
from:
; Default end code
;G1 X0 Y0 Z130 ; Get extruder out of way. Uncomment to use!
M107 ; Turn off fan

to:
; Default end code
;G1 X0 Y0 Z280 ; Get extruder out of way. Uncomment to use!
M107 ; Turn off fan

Then the bed moves down after print, so its easier to access without manually move the z-axis.

Aah yes and as it says in the code: uncomment to use.. So remove ;